No products in the basket.
Spend over £99 and get FREE Delivery.
Over Freezing -6 to -10°C
Problem : The slush machine is not freezing correctly, solution below
Please perform regular maintenance as detailed below. Failure to maintain your machine in accordance with the Easy Start Guide, which came with your machine, will invalidate your warranty.
Snowshock cannot be held responsible for any repair costs (parts or labour) for equipment that has not been maintained in accordance with the Easy Start Guide.
If the machine has recently start to over freezing there are a number of reasons why this may be the case.
If the machine has started freezing on the outside then is it most likely related to an issue with the mixture of the slush. For more information on how to resolve this please see our 'Mix Consistency' articles.
If the machine is freezing below -6°C or to the point where is freezes solid then please follow the steps below.
Step 1
Allow the affected side to defrost. Then place the affected side into the 'Chill Mode' (second position on the freeze switch). With the spiral rotating allow the side to run in Chill Mode for an hour. Then record the temperature.
Step 2
Now place the affect side into the Freeze Mode (first position on the freeze switch). With the spiral rotating allow the side to run for an hour, then record the temperature.
If at any point the tank freezes solid turn off the rotation, record the temperature and defrost the tank.
Step 3
Depending on your results please follow the next listed step:
Both the same temperature - Step 4
Colder in Freeze Mode than Chill - Step 5
Colder in Chill Mode than Freeze - Step 6
Step 4
If you are finding that both freeze and chill modes are causing the machine to over freeze or freeze solid then first made sure that the Freeze adjustment on the back of the affected tank is set to the top of the gauge. Then if the problem continues it is likely that a coil have gone in the machine. New coils can be purchased from our website.
Step 5
If the machine is showing as colder in the Freeze Mode than Chill this would suggest that a Limit switch in the machine has failed and would need to be replaced. Limit Switches can be purchased from our website.
Step 6
If the machine is colder in the Chill Mode than the Freeze Mode then it may indicate an issue with the thermostat for which an engineer may be necessary.
Did this resolve your issues?
Yes
No
Need further assistance?
If you are still having trouble then why not let us know who you, what you have tried and what seems to be the problem?We will contact you as soon as possible.Further Information
Common Solutions
Leaky Machine?
Most leaks can be fixed by a good cleaning. Make sure you are removing any dirt or grime that may have built up or your seals as this is most likely what is causing the problem. Any marks or stains that cannot be removed may indicate that the seal needs to be replaced. Remember to lubricate the seals before they are replaced, failing to do so will cause the machine to leak.
Not Freezing?
One of the most common causes of the machine not freezing is a blocked air filter. The air filter can be found on the side of the machine opposite from the switches. By removing the panel you will find a foam filter, which should be cleaned in hot soapy water, and behind that a metal grill; which should be cleaned with a vacuum cleaner, taking care not bend the metal fins.
Clicking or knocking noise?
This can be a common noise, especially with new machines. The motors in the back of each barrel swing whilst the machine is cooling down. This can sometimes produce a clicking or knocking noise. There is no cause for concern as the noise will fade over a couple of weeks as the machine beds-in. However should the noise continue or worsen it may indicate a problem in the machine. Take a look at our noise section to find out more.
